Minelab Gold Monster 1000 Metal Detector Free Shipping

  

The GOLD MONSTER 1000 features fully automatic operation and comes with a choice of coils, battery options and shaft configurations. If you're looking for super sensitive gold performance at a great price, then this is the detector you've been waiting for! "I found my first nugget within an hour" I found my first nugget within an hour; funnily enough it was in a detector scrape from previous excursions.

All up I found many pieces of gold, the deepest being 3 inches in variable hot ground. I was able to find nine small nuggets (flakes) so easily that it was a bit surprising!

Total weight of all nine is 7.8 grains. None were deep, maybe 34 cm at most. Just enough however to be just out of reach of the SDC and too small for the GPZ.

Extra sensitive 45 kHz VLF performance. Manual sensitivity, and two auto options; Auto, and Auto+. Adjust to suit your hearing, with 6 volume levels.

Waterproof coil (to 1m/3')/ Rain proof control box. GOLD MONSTER 1000 outperforms all other single frequency VLF gold detectors! Detector sensitivity comparisons are representative only.

Actual performance will depend upon nugget size, detector settings and ground conditions. Up until now, there has always been a compromise between frequency and sensitivity when optimising detector performance, because lower frequencies are more sensitive to larger gold nuggets and higher frequencies are more sensitive to smaller gold nuggets.

When comparing detectors, the three curves in the diagram represent each detectors ability to find small gold nuggets of a certain size, at a maximum possible depth. Most detectors will find a very large nugget just beneath the surface, however a detectors sensitivity to gold determines how many smaller nuggets will ultimately be recovered in difficult (noisy) ground at greater depths.

An 18 kHz detector will normally have a depth advantage on nuggets 1.0g over a basic mid-frequency detector, and a 71 kHz detector will have a depth advantage on nuggets 0.1g. The advanced GOLD MONSTER 1000 uses an intermediate 45 kHz frequency AND a high speed 24-bit signal processor. This primary combination greatly boosts sensitivity to gold beyond that of other single frequency VLF detectors over a wide range of nugget sizes, without introducing excess noise and false signals. The GOLD MONSTER 1000 also has improved ferrous/non-ferrous discrimination and copes better with conductive (salty) soils than higher frequency detectors, making it the perfect choice to maximise your gold recovery!

Automatic noise cancel Digital electronics Auto ground balance Faster processor Automatic sensitivity. The item "Minelab Gold Monster 1000 Metal Detector Free Shipping" is in sale since Wednesday, September 20, 2017.

This item is in the category "Business & Industrial\Test, Measurement & Inspection\Test Meters & Detectors\Metal Detectors". The seller is "charman-2009" and is located in Aurora, Illinois. This item can be shipped to United States.

• Model: Minelab Gold Monster 1000
• Country/Region of Manufacture: Australia
• MPN: 3317-0001
• Brand: Minelab
• Intended Use: General Purpose
• Type: Handheld
• Features: Discrimination Knob